Table of Contents
Advertisement
Set-up
Operating Instructions 610/630 - 00.0 - 05/2014
The working height is continuously adjustable between 750
and 950 mm (measured to the upper edge of the table plate).
The frame height should be appropriate to the height and position
of the operator.
1. Release the screws (2) on both bars of the frame.
2. Pull out or push in the table plate evenly at both sides to prevent
it from jamming.
The scales (1) on the outside of the bars serve as an adjust-
ment aid.
3. Tighten both screws (2).
6.4.1
Electrical connection
DANGER
Risk of injury from electricity.
Unprotected contact with electricity can result in
serious injuries or death.
Work on the electrical system must ONLY be
performed by qualified electricians or appropriately
trained and authorized personnel.
ALWAYS unplug the power plug before working
on the electrical equipment.
6.4.2
Checking the mains voltage
The rated voltage and mains voltage specified on the controller
type plate must be the same.
61
Advertisement
Table of Contents
