Software settings
Operating Instructions 610/630 - 00.0 - 05/2014
7.6.1
Adjustable parameters AUTO
The following table describes the adjustable parameters
in the automatic operating mode AUTO.
Icons
1. Press the desired button.
The user interface for adjusting the desired parameter is
displayed.
With some parameters, the setting extends beyond a numerical
value. These complex-structured parameters are explained in the
following.
Meaning
Program selection,
Select right or left sewing part
Set the sewing material size,
Other program parameters in automatic
mode AUTO,
pg. 84.
Set fullness temporarily until the next
segment,
pg. 82
Correct fullness in % for all segments,
pg. 83
Adjust the needle thread tension. If the
value is changed in automatic mode
AUTO, it is saved permanently
in the program.
Set stitch length in mm. If the value
is changed in automatic mode AUTO,
it is saved permanently in the program.
pg. 80
pg. 81
79