Parameter Programming Mode - DURKOPP ADLER 540-100-1 Manual Complete

5.3 Parameter programming mode

Buttonhole number
P1
Cut length
P2
Speed
P3
Buttonhole seam
parameter
P4
Starting variants
P5
Upper bartack
parameter
P6
Lower bartack
parameter
P7
2x seams
P8
Knitwear sewing
mode
P9
Basting stitches
P10*
Zigzag seams
P11*
Cutting
P12*
Copying from
P13
*) Those programs are only visible, if the P9 (Knitwear sewing mode) is switched on.
1 ... 50
6.0 ... 65.0 mm
200 ... 4000 RPM
A,B,C,D
ON / OFF
ON / OFF
Mú
êM
úú
0 ... 50
Selection of the buttonhole number
Dependent on buttonhole
Select the submenu for the selection of
buttonhole seam parameters
Selection of the sewing start variants
Select the submenu to adjust the upper
bartack
Select the submenu to adjust the lower
bartack
Switching on/off of the double-stitching of the
whole buttonhole (the buttonhole is sewn
twice).
Switching the knitwear sewing mode on or off
Selection of the submenu for the setting of the
number of the basting stitches and the display
of the characteristics
Selection of the submenu for the setting of a
second zigzag seam and the display of the
characteristics
Cutting during the last cycle
Cutting during the cycle before the last one
Cutting during both cycles
The buttonhole data of the chosen buttonhole
number is copied into the currently active
buttonhole.
1
29