Left-hand steering vehicle
Right-hand steering vehicle
ELECTRONIC CONTROL SYSTEM
MAIN RELAY
Inspection
1) Disconnect negative cable at battery.
2) Remove main relay from connector.
1. Main relay
2. Junction (Fuse) box
3) Check resistance between each two terminals as in table below.
If check results are as specified, proceed to next operation
check. If not, replace.
4) Check that there is continuity between terminals "A" and "B"
when battery is connected to terminals "C" and "D".
If malfunction is found, replace.
ENGINE AND EMISSION CONTROL SYSTEM (G16 / J20 ENGINE) 6E1-11
TERMINALS
Between A and B
Between C and D
RESISTANCE
(Infinity)
79 – 95
at 20 C, 68 F