ASSEMBLY
1) Fully apply joint grease to wheel side joint.
Use joint grease in the tube included in spare part or joint grease
(99000-25120).
2) Fit wheel side boot on shaft.
Fill up inside of boot with joint grease of about 85 gram.
Before fixing boot band, insert screwdriver into boot on joint side
and allow air to enter boot so that air pressure in boot becomes
the same as atmospheric pressure.
3) Fixing boot band.
4) Install boot onto drive shaft till its small diameter side fits to shaft
groove and fix there with boot band.
1. Boot
2. Boot band
5) Install cage to shaft.
CAUTION:
Install cage directing smaller outside diameter side to
shaft end.
1. Cage
6) Install circlip by using snap ring plier.
1. Circlip
7) Apply grease to entire surface of cage.
Use joint grease in tube included in spare part or joint grease
(99000-25120).
FRONT DRIVE SHAFT / SHAFT BEARING, OIL SEAL 4A2-5