Suzuki Canvas SQ416 Service Manual page 65

1. LSPV stay bolt
2. LSPV bolt
3. Brake pipe flare nut
4. Air bleeding plug
1. LSPV stay bolt
2. LSPV stay
2) Torque each bolt and nut to specification as indicated respec-
tively in figure left.
Tightening Torque
.
(a): 23 N
1, (a)
.
(b): 16 N
(c): 7.5 N
3) Upon completion of installation, fill reservoir tank with specified
fluid and bleed air from brake system.
NOTE:
Make sure to bleed air from LSPV bleeder without failure.
4) After bleeding air, check that LSPV is installed properly, referring
to following INSPECTION & ADJUSTMENT.
INSPECTION & ADJUSTMENT
Confirm the following before inspection and adjustment.
Fuel tank is filled with fuel fully.
Vehicle is equipped with spare tire, tools, jack and jack handle.
Vehicle is free from any other load.
With vehicle in above conditions;
1) Place it on level floor.
2) Push up LSPV lever with finger till it stops and measure length
of coil spring ("L" in below figure) as it is pulled.
3) Spring length "L" should be the value specified below.
Spring length (between spring ends)
"L": 103 mm (4.06 in.)
4) If it isn't, adjust it to specification by changing stay positions as
shown in left figure. After adjustment, tighten bolt to specified
torque.
For details, refer to left figure.
Tightening Torque
.
(a): 23 N
NOTE:
Check to make sure that LSPV body and brake pipe joints
are free from fluid leakage. Replace defective parts, if any.
BRAKES PIPE / HOSE / MASTER CYLINDER 5A-3
m (2.3 kg-m, 17.0 lb-ft)
m (1.6 kg-m, 11.5 lb-ft) (brake flare nut)
.
m (0.75 kg-m, 9.0 lb-ft) (bleeder plug)
m (2.3 kg-m, 17.0 lb-ft)