Suzuki Canvas SQ416 Service Manual page 23

1B-14 AIR CONDITIONING (OPTIONAL)
G16 engine
J20 engine
1. Generator belt
2. Compressor drive belt
INSTALLATION
1) Pour new compressor oil. The amount must be the same with
(b)
2) For G16 engine:
3) Connect suction and discharge hoses to compressor.
4) For G16 engine:
5) Connect thermal protector lead wire.
6) Evacuate and charge system according to previously described
3. Compressor pulley
4. Crankshaft pulley
the amount measured in REMOVAL.
NOTE:
Compressor assembly supplied from factory is filled up
with following amount of oil.
Amount of oil in compressor: 120 cm
Install compressor temporarily to bracket, then install compres-
sor drive belt.
For J20 engine:
Install compressor to its bracket.
Tighten bolts (a) first, then (b).
Tightening Torque
.
(a), (b): 23 N m (2.3 kg-m, 17.0 lb-ft)
Tension compressor drive belt by tightening compressor mount-
ing bolts. Refer to Section 3B1 for drive belt tension.
Tighten bolt (a) first, then (b).
Tightening Torque
.
(a): 23 N m (2.3 kg-m, 17.0 lb-ft)
For J20 engine:
Install generator belt. Refer to Section 6H for details.
procedure.
CAUTION:
Be sure to use HFC-134a (R-134a) compressor oil.
3 3
(120 cc, 7.5 in )