Suzuki Canvas SQ416 Service Manual page 55

1. Oil filler / level plug
2. Front drain plug
2
1
1. Differential side joint
2. Tire lever
3. Front differential assembly
REMOVAL (RIGHT SIDE)
1) Hoist vehicle and remove wheel.
2) Drain differential gear oil.
3) Remove axle shaft drive flange.
4) Remove drive shaft circlip and washer.
5) Remove knuckle and wheel hub comp, refer to steps 5) to 7) and
9) to 14) of item COIL SPRING REMOVAL in Section 3D.
1. Circlip
2. Washer
6) Remove drive shaft assembly.
To detach snap ring fitted on the spline of differential side joint
(inboard joint) from differential side gear, pull inboard joint by us-
ing a tire lever.
CAUTION:
To prevent breakage of boots (wheel side and differential
side), be careful not to bring them into contact with other
parts when removing drive shaft assembly.
7) Remove drive shaft thrust washer from drive shaft and remove
drive shaft oil seal as shown in figure.
CAUTION:
Be careful not to cause damage to drive shaft joint.
1. Oil seal
FRONT DRIVE SHAFT / SHAFT BEARING, OIL SEAL 4A2-3