Suzuki Canvas SQ416 Service Manual page 49

1. Lower rod
2. Rear mount nut
Body side
LOWER ROD
REMOVAL
1) Hoist vehicle and remove rear wheel.
2) Support rear axle housing by using floor jack.
1. Axle housing
2. Floor jack
3) Remove lower rod front mount bolt.
1. Lower rod
2. Front mount bolt
4) Remove lower rod rear mount bolt.
INSTALLATION
1) Install lower rod to chassis frame and axle housing, referring to
Axle side
1. Lower rod
2) Remove floor jack from rear axle housing.
2. Front bolt
3. Rear bolt 3) Install wheel and tighten wheel nuts to specified torque.
4. Vehicle body
5. Axle housing
6. Body center
7. Body out side
4) Lower hoist and with vehicle in non loaded condition, tighten
figure for proper installing direction of bolts.
Nuts should not be tightened.
Tightening Torque for wheel nuts
.
95 N m (9.5 kg-m, 69.0 lb-ft)
front bolts and rear bolts and nuts of lower rod to specified
torque.
Tightening Torque
.
(a): 90 N m (9.0 kg-m, 65.0 lb-ft)
REAR SUSPENSION 3E-3