1. Armature plate
4) Install magnet clutch.
(1) Set magnet clutch squarely over clutch installation boss.
(2) Place special tool (D) onto clutch bearing.
Ensure that edge rests only on inner race of bearing.
(3) Install snap ring.
Special Tool
(D): 09991-06010
CAUTION:
Be careful not to scratch bearing seal.
5) Adjust clearance, between armature plate and magnet clutch by
putting shim on compressor shaft.
Standard clearance "a": 0.3 – 0.5 mm (0.012 – 0.02 in.)
"a"
6) Tighten new armature plate nut as specified below.
Tightening Torque
.
(a): 14 N
Special Tool
(A): 09991-06020
AIR CONDITIONING (OPTIONAL) 1B-17
m (1.4 kg-m, 10.5 lb-ft)