Suzuki Canvas SQ416 Service Manual page 61

5-2 BRAKES
1. Air bleeder plug
2. Weight
3. Attachment
CHECK AND ADJUSTMENT
FLUID PRESSURE TEST(if equipped with
LSPV)
Test procedure for LSPV assembly is as follows.
Before testing, confirm the following.
Fuel tank is filled with fuel fully.
Vehicle is equipped with spare tire, tools, jack and jack handle.
1) Stop vehicle on level floor and place approximately about 200
kg (441 lbs) weight on rear housing so that rear axle weighs 800
kg (1764 lb).
Rear axle weight "L": 800 kg (1764 lb)
2) Install special tool to front and rear brake.
NOTE:
Special tool should be connected to breather of front (driv-
er's side brake) and rear brakes.
Special Tool
2
Front brake
(A): 09956-02310
"L"
(C): 55473-82030 (Air bleeder plug supplied as a spare part)
Rear brake
(A): 09956-02310
(B): 09952-36310
(C): 55473-82030 (Air bleeder plug supplied as a spare part)
NOTE:
Special tool (B) is used instead of thread diameter 10 mm
attachment of special tool (A).
So remove the attachment from (A) and install (B) as shown
in figure.
3) Depress brake pedal gradually till fluid pressure of front brake
becomes as specified below and check corresponding pressure
of rear brake then. It should be within specification given below.
As done above, apply 100 kg/cm
check that rear brake pressure then is within specification as giv-
en below.
Front brake
8,000 kPa
2 2
80 kg/cm 80 kg/cm
1,138 psi
Front brake
10,000 kPa
2 2
100 kg/cm 100 kg/cm
1,422 psi
Rear brake
6,000 – 7,300 kPa
2 2
60 – 73 kg/cm 60 73 kg/cm
853 – 1,038 psi
2
pressure to front brake and
Rear brake
6,500 – 8,000 kPa
2 2
65 – 80 kg/cm 65 – 80 kg/cm
924 – 1,138 psi