Suzuki Canvas SQ416 Service Manual page 114

NG NG
1. Exhaust hole
WARNING:
For handling and storage of a live seat belt pretensioner,
select a place where the ambient temperature below
65 C (150 F), without high humidity and away from elec-
tric noise.
Never carry the seat belt pretensioner by the wires or
connector on the underside of the pretensioner.
When placing a live seat belt pretensioner on the work-
bench or some place like that, be sure not to lay it with
its exhaust hole provided side facing down. It is also pro-
hibited to put something on its face with an exhaust hole
or to put a seat belt pretensioner on top of another.
Otherwise, personal injury may result.
FRONT SEAT BELT WITH PRETENSIONER
INSPECTION
When checking seat belt with pretensioner, use following check
items in addition to those specified for seat belt without pretension-
er described in the same section of the Service Manual mentioned
in FOREWORD of this manual.
WARNING:
Never measure resistance of pretensioner or disassemble
it. Otherwise, personal injury may result.
CAUTION:
If seat belt pretensioner (retractor assembly) was dropped
from a height of 30 cm (1 ft) or more, it should be replaced.
Check retractor assembly with seat belt pretensioner appearance
visually for following symptoms and if any one of them is applicable,
replace it with a new one as an assembly.
Pretensioner has activated.
There is a crack in seat belt pretensioner (retractor assembly).
Wire harness or connector is damaged.
Seat belt pretensioner (retractor assembly) is damaged or a
strong impact (e.g., dropping) was applied to it.
SEAT BELT 10A-3