Suzuki Canvas SQ416 Service Manual page 41

3D-4 FRONT SUSPENSION
1. Spring seat
INSTALLATION
Reverse removal procedure to install coil spring.
NOTE:
Upper and lower diameters of coil spring are different.
Bring larger diameter end at bottom and set its open end in
place on spring seat.
"a" < "b"
"A"
1. Circlip
2. Large diameter
2, (a)
1. Axle shaft drive flange
2. Bolt
Be sure to use specified torque for tightening each fastener.
Refer to torque specification chart at the end of this section.
As for ball stud nut, be sure to use new nut.
Tighten tie-rod end nut with pushing ball stud to upper side so as
not ball stud to be rotated.
Apply lithium grease to front drive shaft washer and front wheel
spindle outer.
"A": Grease 99000-25010
When installing circlip to drive shaft, utilize screw hole in drive
shaft to pull it out and bring large diameter of circlip at right as
shown.
When installing axle shaft drive flange to wheel hub, apply sealant
to mating surface of axle shaft drive flange and tighten flange bolt
to specified torque.
"A": Sealant 99000-31090
Tightening Torque
.
(a): 48 N m (4.8 kg-m, 35.0 lb-ft)