Suzuki Canvas SQ416 Service Manual page 43

3D-6 FRONT SUSPENSION
KNUCKLE/WHEEL SPINDLE
REMOVAL
1) Hoist vehicle and remove wheel.
2) Remove axle shaft drive flange, drive shaft circlip and washer.
Refer to steps 3) to 4) of item COIL SPRING REMOVAL in this
section.
3) Remove wheel hub. Refer to steps 3) to 9) of item WHEEL
HUB/BEARING/OIL SEAL REMOVAL in this section.
4) Disconnect tie-rod end from knuckle.
5) Remove ball stud nut.
6) Support lower arm with jack.
7) Remove strut bracket bolts from strut bracket.
1. Strut
2. Knuckle
8) By using puller, disconnect knuckle from ball stud.
9) While lowering jack, remove knuckle/wheel spindle comp.
10) Remove inner oil seal, dust cover and wheel spindle.
1. Dust cover
2. Wheel spindle
3. Knuckle
4. Inner oil seal