Suzuki Canvas SQ416 Service Manual page 85

7B1-2 AUTOMATIC TRANSMISSION (4 A / T)
MANUAL SELECTOR ASSEMBLY (FOR LH VEHICLE)
1. Interlock cam pin
(only for new selector assembly)
ON-VEHICLE SERVICE
REMOVAL
1) Disconnect negative cable at battery.
2) Remove console box.
3) Disconnect connector for illumination lamp, shift lock solenoid
(if equipped) and overdrive OFF switch.
4) Disconnect interlock cable from interlock cam of selector as-
sembly (if equipped).
5) Remove selector assembly mounting bolts.
6) Disconnect select cable from lever of selector assembly.
INSTALLATION
NOTE:
If equipped with brake interlock system, new selector assem-
bly is supplied with held interlock cam at interlock cable con-
necting position with pin. Remove this pin after connecting in-
terlock cable to interlock cam and tightening cable nut.
Reverse removal procedure to install noting the followings.
Connect interlock cable end to cam referring to "Interlock Cable
Installation" section (if equipped).
Upon completion of installation, confirm that brake (key) interlock
system operates properly (if equipped).
1. Manual selector assembly
(Select lever assembly)
2. Manual lever assembly
3. Select cable bracket
4. Select indicator
5. Slide cover
6. Select lever knob
7. Spring
8. Knob button
9. Shift lock solenoid rod
10. Shift lock solenoid
11. Cover
12. Illumination lamp
13. Interlock cam
Tightening Torque
(Manual selector assembly bolts)
.
(a): 18 N m (1.8 kg-m, 13.5 lb-ft)