Ignition switch side
1. Ignition switch ass'y
2. Clamp screw
3. Interlock cable
Select lever side
1. Inner end of interlock cable
2. Interlock cam
3. Stud bolt
1. Ignition switch ass'y
2. Clamp screw
3. Outer end
KEY INTERLOCK CABLE (IF EQUIPPED)
NOTE:
Don't bend interlock cable excessively when removing and
installing it, or system will not operate correctly.
Removal
1) Disconnect negative (–) cable from battery.
2) If equipped with air bag system, disable air bag system.
Refer to "Disabling Air bag System" in Section 10B.
3) Remove steering column hole cover.
4) Tilt steering column if steering column is adjustable.
If no adjustable, loosen steering column bolts.
5) Remove steering column cover.
6) Remove interlock cable clamp screw located at ignition switch
ass'y.
7) Remove disconnect interlock cable inner end.
(Ignition switch side.)
8) With console box removed, take out interlock cable by loosening
lock nuts.
9) Detach cable end from interlock cam while pressing claws of in-
terlock cam boss. At this time, be careful not to cause damage
to its claws.
4. Cam boss
5. Claw
Installation
1) Shift select lever to "N" range and turn ignition key to "ACC" posi-
tion.
2) Connect inner end of interlock cable to key interlock lever (Igni-
tion switch side).
3) Install outer end bracket of interlock cable to ignition switch as-
sembly, and tighten screw to specified torque.
Tightening Torque
(a): 2.2 N
AUTOMATIC TRANSMISSION (4 A / T) 7B1-3
.
m (0.22 kg-m, 1.5 lb-ft)