Preparing The System Chassis; Chassis Preparation/Slot Selection Procedure - Motorola MVME167 Series Installation Manual

Hardware Preparation and Installation

Preparing the System Chassis

3
!
Caution
!
Warning
Table 3-8. Chassis Preparation/Slot Selection Procedure
Step
1 Turn all power OFF to chassis and peripherals
2 Disconnect AC power cable
Remove chassis cover as shown in the user's manual
3
chassis or system
4 Remove the Þller panel(s) from the appropriate card slot(s) at the front and rear
of the chassis (if the chassis has a rear card cage).
If the MVME167 is conÞgured as
system controller:
It must be installed in the
left-most card slot (slot 1) to correctly
initiate the bus-grant daisy-chain and
to have proper operation of the IACK-
daisy-chain driver.
3-14
Now that the MVME167 is ready for installation, prepare the
system chassis and determine slot assignments (for peripherals,
transition modules, etc.) as follows:
Inserting or removing modules while power is applied
could result in damage to module components.
Dangerous voltages, capable of causing death, are
present in this equipment. Use extreme caution when
handling, testing, and adjusting.
from source
.
Action
.
.
If it is not conÞgured as system
controller:
It may be installed in any double-
height unused card slot.
for your particular