Programming Remote Control Signals For A Key Or Button - Learning Function (Learn) - Sony RM -NX7000 Operating Instructions Manual

Program m ing rem ot e cont rol signals for a key
or but t on – Learning funct ion (LEARN)
You can teach remote control signals for an component to any of the
programmable function keys on the Component display, and buttons on the
Remote Commander.
Using this learning function, you can set the Remote Commander to operate
components or to have functions of components when they are not controllable
even if you have programmed the preset codes. You can also use the learning
function to change the function of individual keys and buttons after
programming the preset code.
Notes
• While learning, do not disconnect or connect the USB cable or the AC power adaptor, or
do not remove or insert a "Memory Stick", as a malfunction may result.
• Certain remote control signals may not be learned depending on the remote control
signal of the component to be programmed.
• Before performing the learning function, install new batteries in the remote control of
the component whose signal is to be learned, and fully charge the Remote Commander
or connect the AC power adaptor to the Remote Commander. (When the E mark is lit,
you cannot use the learning function, as the Remote Commander cannot enter the
setting mode.
• Avoid performing the learning function in places under direct sunlight or strong
fluorescent light. (It may cause noise.)
• You cannot set learning signals to the Component keys or the buttons when the Home
display is shown.
• You cannot set learning signals to certain function keys or buttons. Function keys that
are not learnable appear pressed. If you press one of these keys, a beep sounds twice. If
you press a function button that is not learnable, a message appears.
Press t he [SET] key f or 2 seconds or longer in t he
1
Hom e display.
The Set display appears.
Press t he [COM PONENT EDIT]
2
key.
The Component edit display appears.
58
Downloaded from: https://www.usersmanualguide.com/