Table of Contents
Advertisement
Removing the memory card
To remove the optional memory card, reverse the steps listed in "Installing
additional memory" on page 13. To remove the factory-installed memory, follow
these steps:
1. Remove the back cover as described in "Removing the back cover" on page 28.
2. Remove the memory card from its slot.
3. To replace the memory card, reverse these steps.
Removing the hard drive fan
To remove and replace the hard drive fan, follow these steps:
1. Remove the back cover as described in "Removing the back cover" on page 28.
2. Detach the fan connector ( C in Figure 20) from the system board.
Figure 20. Removing the hard drive fan
3. Using a Philips screwdriver, remove the two screws located on each side of the
4. Lift the fan ( B ) from its housing.
5. To replace the hard drive fan, arrange the notches on the fan brackets under
6. Replace the two screws.
7. Plug the fan connector ( C ) back into the system board.
All manuals and user guides at all-guides.com
hard drive fan ( A in Figure 20).
the hooks of the mounting tabs. Then rotate the fan into place.
Chapter 4. Removing and replacing FRUs
33
Advertisement
Table of Contents
