Installing A Security Rope Clip - IBM IntelliStation Z Pro 6223 Installation Manual

14. Replace the air baffle for the microprocessors. Slant the front of the air baffle
15. Rotate the drive cage back into the computer and reconnect the fan connector
16. If you have other options to install or remove, do so now. Otherwise, then, go

Installing a security rope clip

To help prevent hardware theft, you can add a security rope clip and cable to your
computer. After you add the security cable, make sure that it does not interfere with
other cables that are connected to the computer.
Before you begin, obtain the following items:
v A flat-blade screwdriver
v An adjustable wrench
v A 19-mm (0.75-in.) rope clip or wire rope (similar to National Manufacturing
v Threaded nuts that fit the rope clip
v A security cable
v A lock, such as a combination lock or padlock
Complete the following steps to install a rope clip:
1. Turn off the computer and all attached devices.
2. Disconnect all external cables and power cords; then, remove the side cover
3. Use a screwdriver to remove the two metal knockouts.
4. Insert the rope clip through the rear panel; then, attach and tighten the nuts.
for the microprocessors downward at an angle while moving it forward; then,
rotate the rear of the air baffle down until it snaps into place (it will become
stationary).
on the fan assembly on the drive cage to the system board.
to "Completing the installation" on page 41.
number 3230, stock number 176-735)
(see "Removing the side cover" on page 16).
Chapter 2. Installing the hardware
39