Installing A Security Rope Clip - IBM IntelliStation M Pro 6220 User Manual

11. If you have other options to install or remove, do so now. Otherwise, rotate the
12. Replace the cover (see "Replacing the cover" on page 48).
13. Reconnect the external cables and power cords. Turn on the attached devices,

Installing a security rope clip

To help prevent hardware theft, you can add a security rope clip and cable to your
computer. After you add the security cable, make sure that it does not interfere with
other cables that are connected to the computer.
Before you begin, obtain the following items:
v A flat-blade screwdriver
v An adjustable wrench
v A 19 mm (0.75 in.) rope clip or wire rope (similar to National Manufacturing
v Threaded nuts that fit the rope clip
v A security cable
v A lock, such as a combination lock or padlock
Complete the following steps to install a rope clip:
1. Turn off the computer and all attached devices. Disconnect all external cables
2. Use a screwdriver to remove the two metal knockouts.
3. Insert the rope clip through the rear panel; then, attach and tighten the nuts.
remove the DIMM, then reinsert it.
DIMM
connector 1
drive cage back into the computer and replace the support bracket (see
"Removing and installing the support bracket" on page 33).
and turn on the computer.
number 3230, stock number 176-735)
and power cords; then, remove the cover. See "Removing the cover" on page
33.
DIMM
connector 2
DIMM
connector 3
DIMM
connector 4
Chapter 4. Installing options
47