Installing The Lan Driver (Windows Server 2003) - Fujitsu Primergy TX120 User Manual

Chapter 4 Manual OS Installation
3
Click [Reinstall Driver] in the [General] tab window.
The [Welcome to the Hardware Update Wizard] window appears.
4
Check [No, not this time] and click [Next].
5
Select [Install the software automatically (Recommended)] and click [Next].
The driver will be installed.
6
Click [Finish].
7
Click [Close] to close the properties window.
8
Remove the driver disk and restart the system.
After LAN driver installation, names of the LAN devices are displayed as follows.
Onboard LAN (1000BASE-T)
PG-1882L
PG-1892L
PG-2861L
PG-289L

4.3.2 Installing the LAN Driver (Windows Server 2003)

The LAN driver installation procedure differs depending on whether the network adapter was
recognized during the OS installation.
Updating LAN Drivers
Perform the following procedures on all LAN device names under [Network adapters] in [Device
Manager].
1
Click [Start] → [Administrative Tools] → [Computer Manager].
2
Click [Device Manager].
3
Double-click a LAN device name under [Network adapters].
4
Insert the driver disk created from the ServerStart CD-ROM into the server, it is
according to the installed LAN device.
5
Click [Update Driver] in the [Driver] tab window.
The "Welcome to the Hardware Update Wizard" window appears.
120
table: LAN device name
LAN cards
Broadcom NetXtreme Gigabit Ethernet
Intel(R) PRO/1000 MF Server Adapter
Intel(R) PRO/1000 MT Server Adapter
Intel(R) PRO/1000 PT Dual Port Server Adapter
Intel(R) PRO/1000 PT Server Adapter
LAN device name