Fujitsu Primergy TX120 User Manual page 251

4
Press the [2] key and select "Power Management".
The Power Management menu appears.
****************************************
* Welcome to PRIMERGY Remote Manager
* Firmware Revision x.xxA (x.xx)
* SDRR *.** ID 0203
* Firmware built xxx xx xxxx xx:xx:xx *
****************************************
System Type : PRIMERGY TX120
System ID : xxxxxxxx
System Name : TX120-2 (xxx.xxx.xxx.xxx)
System OS : xxxxxxxx
System Status: OK
Power Status : On
Power Management Menu
(1) Immediate Power Off
(2) Immediate Reset
(3) Power Cycle
(*) Power On
(*) Graceful Power Off (Shutdown)
(*) Graceful Reset
Enter selection or (0) to quit:
5
Select a menu and press the corresponding number key.
"*" is displayed in the bracket of unavailable menu.
Menu name
Immediate Power Off
Immediate Reset
Power Cycle
Power On
Graceful Power Off
(Shutdown)
Graceful Reset
-
6
If pressing the [1], [2], [3], [4], [5] or [6] key, perform the following operation.
When "Do you really want reboot (Yes/No)?" appears, enter "Yes" and press the [Enter] key.
For [3], [5] or [6], the pop-up window "System shutdown due to <software command> in 60
seconds! Press Cancel to abort!" appears when Windows is operating. Select [OK].
*
*
TX120 *
(Reboot)
table: Remote Control Menu
Key
[1] Turns the server off.
Resets the server.
[2]
Turns the server off and back on again. When Windows is
[3]
operating, the server restarts after the OS is shut down.
[4] Turns the server on.
Shuts down the OS and turns the server off. When
[5]
Windows is operating, the server is turned off after the OS
is shut down.
Shuts down the OS and resets the server. When Window is
[6]
operating, the server is reset after the OS is shut down.
Exits the remote controller.
[0]
PRIMERGY TX120 User's Guide
Operation
251