Installing Internal Hard Disk Units - Fujitsu Primergy TX120 User Manual

7.5 Installing Internal Hard Disk Units

This section explains how to install internal hard disk units.
Before adding an internal hard disk unit, install the OS and turn off the server.
• When installing or removing internal hard disk units, turn off the server, all
peripheral devices, and any other connected devices. Also unplug all power
cables from the outlet.
However, when the array system is configured, the defect hard disk unit can
be replacing without turning off the server.
• Install our genuine internal hard disk units only. Failure to do so may cause a
device failure, fire, or electric shock.
• When installing or removing hardware options, make sure to remove the
screws on the specified points only.
There is a chance of injury if screws other than those on the specified points
are removed. This could also damage the server.
• Touch only the specified part of the printed circuit board.
Failure to do so could cause injury and also damage the server.
PRIMERGY TX120 User's Guide
7
173