Chapter 9 Operation And Maintenance; Daily Maintenance; Checking The Server Condition; Cleaning - Fujitsu Primergy TX120 User Manual

Chapter 9 Operation and Maintenance

9.1 Daily Maintenance

This section explains how to check the status of the operating server, as well as how
to perform daily maintenance.
Information for PRIMERGY
For the latest information on PRIMERGY, update modules, drivers and the software, refer to the Fujitsu
PRIMERGY website.
http://primergy.fujitsu.com

9.1.1 Checking the Server Condition

Checking Each LED
This server is equipped with LEDs that display various hardware conditions.
Check the server status via each LED after starting the server. For positions and functions of each status
LED, refer to "1.3 Component Names and Functions" ( Pg.23).
Server Monitoring Tool (ServerView)
ServerView is software that monitors whether the server hardware is in a normal state in order to protect
important server resources. When using ServerView, the server hardware is monitored all the time. If an
error that could cause trouble is detected, the administrator is notified in real-time which enables early
detection. This allows the server administrator to remove a system error early and avoid trouble.
For an overview and installation of ServerView and other high reliability tools, refer to "1.2.2 High
Reliability Tools" ( Pg.20) and "Chapter 6 High Reliability Tools" ( Pg.153).

9.1.2 Cleaning

Clean the server regularly.
Cleaning the Server
Wipe with a soft, dry cloth. For stains that do not come off with a dry cloth, wipe with a cloth lightly
dampened with a mild detergent. Once the stain has been removed, wipe off any remaining detergent
with a cloth dampened with water. When wiping the server, be sure that no moisture enters the server
machine.
Do not use solvents. Use a mild detergent only. Otherwise, the server may be damaged.
Use a vacuum cleaner periodically to prevent dust buildup in ventilation holes.
212
• Before cleaning, turn off the server and unplug the power cables from the
outlets. Also power off peripherals and disconnect them from the server. Failure
to do so may cause electric shock ( "1.4.3 Turning Off the Server" (Pg.31)).