Fujitsu Primergy TX120 User Manual page 218

Chapter 9 Operation and Maintenance
System CMOS checksum bad - Default
configuration used
System timer error
Real time clock error
Check date and time settings
Previous boot incomplete - Default
configuration used
CPU had been changed - Run SETUP
CPU mismatch detected
Available CPUs do not support the same bus
frequency- system halted!
iRMC Controller Error
Diskette drive A error
Incorrect Drive A type - run SETUP
218
table: List of POST Errors
Message Description
The CMOS setting is invalid. Correct the current settings with
the BIOS Setup Utility. If the message still appears, check the
POST error message or the SEL. If the battery is faulty, it must
be replaced.
System clock error. Power off the server and turn it back on. If
the message still appears, the baseboard must be replaced.
Contact an office listed in the "Contact Information" of "Start
Guide".
Real Time Clock (RTC) error. Start the BIOS Setup Utility and
enter the current date and time. If the message still appears, the
baseboard must be replaced. Contact an office listed in the
"Contact Information" of "Start Guide".
The set date and time are invalid. Start the BIOS Setup Utility
and enter the current date and time. If the message still appears,
the baseboard must be replaced. Contact an office listed in the
"Contact Information" of "Start Guide".
An error was detected due to incompletion of POST at the
previous startup, or power off/reset was performed three times
or more in POST. After restoration, make sure to start BIOS
setup and exit after saving settings.
The CPU has been replaced.
If the correct CPU is installed and this message is displayed,
select [Yes] for the [Reset Configuration Data] setting on the
[Advanced] menu of the BIOS Setup Utility. If the message
still appears, the CPU or baseboard must be replaced. Contact
an office listed in the "Contact Information" of "Start Guide".
The CPU frequency has changed.
If the correct CPU is installed and this message is displayed,
update the BIOS using the BIOS Update Utility supplied with
the CPU. If the message still appears after the update, select
[Yes] for the [Reset Configuration Data] setting on the
[Advanced] menu of the BIOS Setup Utility. If the message
still appears, the CPU or baseboard must be replaced. Contact
an office listed in the "Contact Information" of "Start Guide".
Installed CPU error.
If the correct CPU is installed and this message is displayed,
update the BIOS using the BIOS Update Utility supplied with
the CPU. If the message still appears after the update, select
[Yes] for the [Reset Configuration Data] setting on the
[Advanced] menu of the BIOS Setup Utility. If the message
still appears, the CPU or baseboard must be replaced. Contact
an office listed in the "Contact Information" of "Start Guide".
The iRMC error. Power off the server and turn it back on. If the
message still appears, the baseboard must be replaced. Contact
an office listed in the "Contact Information" of "Start Guide".
Floppy disk drive A error or the settings error. Check whether
the floppy disk drive cable is connected properly. Also check
the settings of [Diskette A] on the [Main] menu of the BIOS
Setup Utility. If the message still appears, the floppy disk drive
cable or the floppy disk drive must be replaced.