Turning Off The Server - Fujitsu Primergy TX120 User Manual

4
Press the power switch on the front of the server.
The server's power LED is lit green.
When the power is turned on, the server performs Power On Self Tests (POST). If any
abnormalities are detected by POST, error messages are displayed ("9.2.2 Error Messages"
( pg.217)).
The server's power
LED is lit green
The time to turn the server off can be set with the ASR setting (on the [Power On/Off] tab) using
ServerView. For details, refer to
If you press the [F12] key right after the POST memory amount check, the Boot Menu is displayed,
where you can change the boot disk ("

1.4.3 Turning Off the Server

1
Open the drive cover.
"1.4.1 Opening the Drive Cover" (pg.29)
3.4 Serious Error Handling (ASR)
"
How to Start the BIOS Setup Utility" ( pg.191)).
• In the event of smoke or sparks, immediately unplug the electric cord.
Failure to do so could lead to a fire or electrocution.
• Follow the procedures below to turn off the server. Data can be lost if
these procedures are not followed correctly.
PRIMERGY TX120 User's Guide
in ServerView User's Guide.
" "
1
"
31