Inserting And Ejecting A Cd-Rom (Dvd-Ram) - Fujitsu Primergy TX120 User Manual

Cautions when Turning the Power Off (When the OS is Windows
Server 2003)
"Do Nothing", "Prompt Input", "Standby", "Hibernation", or "Shutdown" can be specified as the
operating mode of the power switch in the OS settings (normally, "Shutdown" is specified). On this
server, functions corresponding to "Standby" and "Hibernation" are supported as BIOS and hardware
functions. However, some drivers and software installed in the server do not support these functions. For
this reason, functions corresponding to "Standby status" and "Hibernation status" are unavailable on this
server.
When the operating mode is set to "Standby" or "Hibernation", the system may operate improperly or
hard disk data may be corrupted. For details about operating mode settings, refer to the OS manual.

1.4.4 Inserting and Ejecting a CD-ROM (DVD-RAM)

This section explains how to insert and eject a CD-ROM and DVD-RAM. Unless otherwise noted, CD-
ROM includes DVD-RAM.
When using CD-ROMs, note the following points to avoid failures.
Cautions for Handling CD-ROMs
• Do not put labels, or apply ink or pencil, to both sides of the CD-ROM.
• Do not touch or scratch the data side of the CD-ROM.
• Do not bend the CD-ROM or place heavy objects on it.
• When cleaning the CD-ROM, use a slightly wet cloth to wipe it from the center to the edge, and then
wipe it with a dry cloth.
• Do not expose the disk to any fluids.
• Do not store the disk in extremely hot or cold conditions.
• Do not store the disk in humid or dusty conditions.
Cautions for Handling Drives
• Do not use CD-ROMs that do not follow the notes described in "
ROMs" ( pg.33), or distorted, broken, or cracked CD-ROMs. Doing so may cause failures. If these
CD-ROMs are used and the drive fails, the warranty will be invalidated.
• This server supports only circular CD-ROMs. Do not use noncircular CD-ROMs. Doing so may
cause failures. If noncircular CD-ROMs are used and the drive fails, the warranty will be invalidated.
• If commercially available CD-ROM cleaning disks are used, dust may get on the lens. Do not use
CD-ROM cleaning disks.
• Some copy control music CDs cannot be used.
• This server supports CD-ROMs with the following logo. Do not use CD-ROMs without the logo.
Doing so may cause failures.
For information about DVD-RAM drive, refer to the manual which comes with the internal DVD-RAM
unit.
PRIMERGY TX120 User's Guide
Cautions for Handling CD-
1
33