Qlogic SANbox 5602 Installation Manual page 87

0
To configure the switch using the command line interface, do the following:
1. Open a command window according to the type of workstation and
connection:
2. Open an admin session and enter the Set Setup System command. Enter
the values you want for switch IP address (Eth0NetworkAddress) and the
network mask (Eth0NetworkMask). Refer to
page B-81
3. Open a Config Edit session and use the Set Config command to modify the
switch configuration. Refer to the
Config Command" on page B-61
59096-01 A
Ethernet (all platforms): Open a Telnet session with the default switch
IP address and log in to the switch with default account name and
password (admin/password).
telnet 10.0.0.1
Switch Login: admin
Password:
Serial – Windows: Open the HyperTerminal application on a Windows
platform.
a. Choose the Start button, select Programs, Accessories,
HyperTerminal, and HyperTerminal.
b. Select the connection you created earlier and choose the OK
button.
Serial – Linux: Open a command window and enter the following
command:
minicom
Serial – Solaris: Open a command window and enter the following
command:
tip sanbox2
for more information about this command.
SANbox #> admin start
SANbox (admin) #> set setup system
*******
"Set Setup Command" on
"Config Command" on page B-16
for more information.
4 – Installation
Installing a Switch
and "Set
4-21