Qlogic SANbox 5602 Installation Manual page 185

0
threshold
Initiates a configuration session by which to generate and log alarms for selected
events. The system displays each event, its triggers, and sampling window one
line at a time and prompts you for a value. For each parameter, enter a new value
or press the Enter key to accept the current value shown in brackets. These
parameters must be saved in a configuration and activated before they will take
effect. Refer to the
and activating a configuration.
parameters. The switch will down a port if an alarm condition is not cleared within
three consecutive sampling windows (by default 30 seconds). Reset the port to
bring it back online. An alarm is cleared when the threshold monitoring detects
that the error rate has fallen below the falling trigger.
Threshold Monitoring Enabled
CRCErrorsMonitoringEnabled
DecodeErrorsMonitoringEnabled
ISLMonitoringEnabled
LoginMonitoringEnabled
LogoutMonitoringEnabled
LOSMonitoringEnabled
Rising Trigger
Falling Trigger
Sample Window
59096-01 A
"Config Command" on page B-16
Table B-21
Table B-21. Set Config Threshold Parameters
Parameter
B – Command Line Interface
Set Config Command
for information about saving
describes the Set Config Threshold
Description
Master enable/disable parameter for all
events. Enables (True) or disables (False)
the generation of all enabled event alarms.
The default is False.
The event type enable/disable parameter.
Enables (True) or disables (False) the
generation of alarms for each of the
following events:
CRC errors
Decode errors
ISL connection count
Device login errors
Device logout errors
Loss-of-signal errors
The event count above which a rising
trigger alarm is logged. The switch will not
generate another rising trigger alarm for
that event until the count descends below
the falling trigger and again exceeds the
rising trigger.
The event count below which a falling
trigger alarm is logged. The switch will not
generate another falling trigger alarm for
that event until the count exceeds the
rising trigger and descends again below
the falling trigger.
The period of time in seconds in which to
count events.
B-67