Qlogic SANbox 5602 Installation Manual page 189

0
The following is an example of the Set Config Security command:
SANbox #> admin start
SANbox (admin) #> config edit
SANbox (admin-config) #> set config security
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
FabricBindingEnabled
AutoSave
Finished configuring attributes.
This configuration must be saved (see config save command) and
activated (see config activate command) before it can take effect.
To discard this configuration use the config cancel command.
59096-01 A
(True / False) [False]
(True / False) [True ]
B – Command Line Interface
Set Config Command
B-71