Qlogic SANbox 5602 Installation Manual page 172

B – Command Line Interface
Security Command
history
Displays history information about the security database and the active security
set including the account name that made changes and when those changes
were made. This keyword does not require an Admin session.
limits
Displays the current totals and the security database limits for the number of
security sets, groups, members per group, and total members. This keyword does
not require an Admin session.
list
Displays all security sets, groups, and group members in the security database.
This keyword does not require an Admin session.
restore
Reverts the changes to the security database that have been made during the
current Security Edit session since the last Security Save command was entered.
save
Saves the changes that have been made to the security database during a
Security Edit session. Changes you make to any security set will not take effect
until you activate that security set. Refer to the
page B-57
Examples
The following is an example of the Security Active command:
SANbox #> security active
Active Security Information
SecuritySet
-----------
alpha
B-54
for information about activating a security set.
Group GroupMember
----- -----------
group1 (ISL)
10:00:00:00:00:10:21:16
Authentication
Primary Hash
Primary Secret
Secondary Hash
Secondary Secret
Binding
10:00:00:00:00:10:21:17
Authentication
Primary Hash
Primary Secret
Secondary Hash
Secondary Secret
Binding
"Securityset Command" on
Chap
MD5
********
SHA-1
********
0
Chap
MD5
********
SHA-1
********
0
0
59096-01 A