Qlogic SANbox 5602 Installation Manual page 157

0
9. Open an Admin session to acquire the necessary authority.
10. Display the list of firmware image files on the switch to confirm that the file
was loaded.
11. Unpack the firmware image file to install the new firmware in flash memory.
12. Wait for the unpack to complete.
13. A message will prompt you to reset the switch to activate the firmware.
Resetting the switch is disruptive. Use the Hotreset command to attempt a
non-disruptive activation.
Examples
The following is an example of the Image Install command:
SANbox (admin) #> image install
Warning: Installing new firmware requires a switch reset.
Continuing with this action will terminate all management sessions,
including any Telnet sessions. When the firmware activation is complete,
you may log in to the switch again.
Do you want to continue? [y/n]: y
Press 'q' and the ENTER key to abort this command.
User Account
IP Address
Source Filename : 5.0.00.11_mpc
About to install image.
Connected to 10.20.33.130 (10.20.33.130).
220 localhost.localdomain FTP server (Version wu-2.6.1-18) ready.
331 Password required for johndoe.
Password: xxxxxxxxx
230 User johndoe logged in.
bin
200 Type set to I.
verbose
Verbose mode off.
This may take several seconds...
The switch will now reset.
Connection closed by foreign host.
59096-01 A
SANbox $>admin start
SANbox (admin) $>image list
SANbox (admin) $>image unpack filename
image unpack command result: Passed
SANbox (admin) $>hotreset
: johndoe
: 10.20.33.130
Do you want to continue? [y/n] y
B – Command Line Interface
Image Command
B-39