Qlogic SANbox 5602 Installation Manual page 188

B – Command Line Interface
Set Config Command
The following is an example of the Set Config Port command for a 10-Gbps port:
SANbox #> admin start
SANbox (admin) #> config edit
SANbox (admin-config) #> set config port 16
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
Configuring Port Number:
------------------------
AdminState
LinkSpeed
PortType
SymPortName
DeviceScanEnable (True / False)
ForceOfflineRSCN (True / False)
AutoPerfTuning
LCFEnable
MFSEnable
VIEnable
MSEnable
IOStreamGuard
Finished configuring attributes.
This configuration must be saved (see config save command) and
activated (see config activate command) before it can take effect.
To discard this configuration use the config cancel command.
SANbox (admin-config) #>
B-70
16
(1=Online, 2=Offline, 3=Diagnostics, 4=Down) [Online
(10=10Gb/s)
(G / F)
(string, max=32 chars)
(True / False)
(True / False)
(True / False)
(True / False)
(True / False)
(Enable / Disable / Auto)
0
]
[10Gb/s ]
[G ]
[10G-16 ]
[True ]
[False ]
[Fales ]
[False ]
[False ]
[False ]
[True ]
[Disabled]
59096-01 A