Qlogic SANbox 5602 Installation Manual page 186

B – Command Line Interface
Set Config Command
zoning
Initiates an editing session in which to change switch zoning attributes. The
system displays each parameter one line at a time and prompts you for a value.
For each parameter, enter a new value or press the Enter key to accept the
current value shown in brackets.
Parameter
InteropAutoSave
DefaultVisibility
DiscardInactive
B-68
Table B-22. Set Config Zoning Parameters
Available only when the InteropMode parameter is Standard,
this parameter enables (True) or disables (False) the saving of
changes to active zone set in the switch's permanent memory.
Refer to "InteropMode" on page
Disabling the Autosave parameter can be useful to prevent
the propagation of zoning information when experimenting
with different zoning schemes. However, leaving the Autosave
parameter disabled can disrupt device configurations should a
switch have to be reset. For this reason, the Autosave
parameter should be enabled in a production environment.
Enables (All) or disables (None) communication among the
switch's ports/devices and the fabric in the absence of an
active zone set. The default is All.
Enables (True) or disables (False) the discarding of all
inactive zone sets from that zoning database. Inactive zone
sets are all zone sets except the active zone set. The default
is False.
Description
B-66. The default is True.
0
59096-01 A