Qlogic SANbox 5602 Installation Manual page 180

B – Command Line Interface
Set Config Command
Parameter
PortType
SymbolicPortName
ALFairness
(1-Gbps/2-Gbps
ports only)
DeviceScanEnabled
ForceOfflineRSCN
ARB_FF
(1-Gbps/2-Gbps
ports only)
InteropCredit
ExtCredit
(1-Gbps/2-Gbps
ports only)
FANEnable
(1-Gbps/2-Gbps
ports only)
B-62
Table B-18. Set Config Port Parameters (Continued)
Port type:
1-Gbps/2-Gbps Ports: GL, G, F, FL, Donor. The default
is GL.
10-Gbps Ports: G
Descriptive name for the port. The name can be up to 32
characters excluding #, semicolon (;), and comma (,). The
default is Port n where n is the port number.
Arbitration loop fairness. Enables (True) or disables
(False) the switch's priority to arbitrate on the loop. The
default is False.
Enables (True) or disables (False) the scanning of the
connected device for FC-4 descriptor information during
login. The default is True.
Enables (False) or disables (True) the immediate
transmission of RSCN messages when communication
between a port and a device is interrupted. If enabled, the
RSCN message is delayed for 200 ms for locally attached
devices and 400 ms for devices connected through other
switches. The default is False. This parameter is ignored if
IOStreamGuard is enabled.
Send ARB_FF (True) instead of IDLEs (False) on the loop.
The default is False.
Interoperability credit. The number of buffer-to-buffer
credits per port. 0 means the default (16) is unchanged.
Changing interoperability credits is necessary only for
E_Ports that are connected to non-FC-SW-2-compliant
switches. Contact your authorized maintenance provider
for assistance in using this feature.
Extended credits. The number of port buffer credits that
this port can acquire from donor ports. The default is 0.
Fabric address notification. Enables (True) or disables
(False) the communication of the FL_Port address, port
name, and node name to the logged-in NL_Port. The
default is True.
Description
0
59096-01 A