Qlogic SANbox 5602 Installation Manual page 200

B – Command Line Interface
Set Setup Command
DeviceAuthServer
UserAuthServer
AccountingServer
Timeout
Retries
SignPackets
Secret
B-82
Table B-23. RADIUS Service Settings (Continued)
Entry
Enable (True) or disable (False) this server for device
authentication. The default is False.
Enable (True) or disable (False) this server for user
account authentication. A user authentication RADIUS
server requires a secure management connection (SSL).
The default is True.
Enable (True) or disable (False) this server for auditing of
activity during a user session. When enabled, user activity
is audited whether UserAuthServer is enabled or not.The
default is False. The accounting server UDP port number
is the ServerUDPPort value plus 1 (default 1813).
Number of seconds to wait to receive a response from the
RADIUS server before timing out. The default is 2.
Number of retries after the first attempt to establish
communication with the RADIUS server fails. The default
is 0.
Enable (True) or disable (False) the use of sign packets to
protect the RADIUS server packet integrity. The default is
False.
32-byte hex string or 16-byte ASCII string used as a
password for authentication purposes between the switch
and the RADIUS server.
Description
0
59096-01 A