Positioning The Fork Protection; Removing The Fork Legs; Installing The Fork Legs - KTM 125 ECX EU Owner's Manual

SERVICE WORK ON THE CHASSIS

Positioning the fork protection

10.6

Removing the fork legs

x
10.7

Installing the fork legs

x
10.8
–
Position the fork protection on the left fork leg. Mount and tighten screws
Guideline
Remaining screws, chassis
–
Position the brake line. Position the clamp and mount and tighten screws
–
Position the fork protection on the right fork leg. Mount and tighten the screws.
Guideline
Remaining screws, chassis
B00800-11
(All EXC models)
–
Remove the headlight mask with the headlight. (
(XC-W)
–
Remove the start number plate. (
–
Remove the front wheel.
–
Remove screws
–
Remove cable binder
–
Remove screws
–
Hang the brake caliper and the brake line loosely to the side.
B00798-10
(EXC EU/AUS, XC‑W)
–
Loosen screws
–
Loosen screws
B00799-10
(EXC SIX DAYS)
–
Loosen screws
–
Loosen screws
B00804-10
(All EXC models)
–
Position the fork legs.
Info
The upper milled groove in the fork leg must be flush with the top edge
of the upper triple clamp.
Position bleeder screws
303637-10
M6
M6
p. 53)
( p. 78)
x
and take off the clamp.

.

and take off the brake caliper.

. Remove the fork leg on the left.

. Remove the fork leg on the right.

. Remove the fork leg on the left.

. Remove the fork leg on the right.

toward the front.

46
.

10 Nm (7.4 lbf ft)
.

10 Nm (7.4 lbf ft)
p. 85)