Preparations For Riding On Wet And Muddy Surfaces; Preparations For Riding At High Temperatures And Low Speeds - KTM 125 ECX EU Owner's Manual

PREPARING FOR USE

Preparations for riding on wet and muddy surfaces

6.6

Preparations for riding at high temperatures and low speeds

6.7
–
Change the radiator cap.
–
Mount the rain cover for the air filter.
Rain cover for air filter (59006021000)
Info
Read the KTM PowerParts installation instructions.
–
Adjust the carburetor jetting and setting.
Info
600870-01
Recommendations on the carburetor setting are available from your autho-
rized KTM workshop.
–
Clean the chain.
Chain cleaner (
–
Mount the steel sprocket.
Tip
Do not grease the chain.
–
Clean the radiator fins.
–
Carefully align bent radiator fins.
600868-01
–
If used in sand regularly, replace the piston every 10 operating hours.
–
Mount the rain cover for the air filter.
Rain cover for air filter (59006021000)
Info
Follow the KTM PowerParts mounting instructions.
–
Adjust the carburetor jetting and setting.
Info
600870-01
The recommended carburetor tuning is available from your authorized KTM
workshop.
–
Mount the steel sprocket.
–
Clean the motorcycle. (
–
Carefully align bent radiator fins.
600868-01
–
Check the radiator cap.
Value on the radiator cap
» If the displayed value does not equal the setpoint value:
600872-10
p. 128)
p. 101)
1.8 bar (26 psi)
Warning
Danger of scalding During motorcycle operation, the coolant gets
very hot and is under pressure.
–
Do not remove the radiator cap, radiator hoses or other cooling
system components when the engine is hot. Allow the engine
and cooling system to cool down. In case of scalding, rinse
immediately with lukewarm water.
28