KTM 125 ECX EU Owner's Manual page 99

TUNING THE ENGINE
2 0 0 2
3 0 0 3
4 0 0 0 4
5 0 0 5
–
Remove screws
B00057-10
–
Take locking cap
of the clutch cover.
–
Pull both springs off of the spring insert.
B00056-11
–
Mount the desired auxiliary spring
the clutch cover together.
Auxiliary spring with yellow marking (54637072300)
Auxiliary spring with green marking (54837072100)
Auxiliary spring with red marking (54837072000)
The cut-out of spring insert
Info
B00058-10
Under no circumstances should screw
negative effect on the engine characteristic.
–
Check the O-ring in the locking cap.
–
Position the locking cap.
–
Mount and tighten the screws.
Guideline
Screw, exhaust control cover
.

, adjusting spring , auxiliary spring
 
and adjusting spring

engages in the angle lever.

M5
and spring insert

and slide them into

be turned as this would have a

6 Nm (4.4 lbf ft)
97
out
