Removing The Seat; Mounting The Seat - KTM 125 ECX EU Owner's Manual

SERVICE WORK ON THE CHASSIS

Removing the seat

10.24

Mounting the seat

10.25
Info
The heim joint for the shock absorber at the swing arm is Teflon
coated. It must not be lubricated with grease or with other lubricants.
Lubricants dissolve the Teflon coating, thereby drastically reducing the
service life.
(All 250/300 models)
–
Push splash protector
and tighten screw
Guideline
Screw, top shock
absorber
–
Mount and tighten screw
Guideline
B00816-11 Screw, bottom shock
absorber
Info
The heim joint for the shock absorber at the swing arm is Teflon
coated. It must not be lubricated with grease or with other lubricants.
Lubricants dissolve the Teflon coating, thereby drastically reducing the
service life.
–
Remove the motorcycle from the lift stand. (
–
Remove screw
above.
B00817-10
–
Hook in the front of the seat at the collar bushing of the fuel tank, lower at the rear
and simultaneously push forward.
–
Make sure that the seat is correctly locked in.
B00818-01
–
Mount and tighten screw
Guideline
Remaining screws, chassis
B00817-10
to the side and position the shock absorber. Mount

.

M12
.

M12
. Lift up the seat at the rear, pull it back and then remove from

of the seat fixation.

M6
80 Nm Loctite ® 2701
(59 lbf ft)
80 Nm Loctite ® 2701
(59 lbf ft)
p. 44)
10 Nm (7.4 lbf ft)
55