Checking The Free Travel Of Foot Brake Lever; Adjusting The Basic Position Of The Foot Brake Lever - KTM 125 ECX EU Owner's Manual

BRAKES
7 7
0 0
0 0 6 6

Checking the free travel of foot brake lever

11.9
Warning
Danger of accidents Brake system failure.
–
If there is no free travel on the foot brake lever, pressure builds up on the rear brake circuit. The rear brake can fail due to
overheating. Adjust free travel on foot brake lever according to specifications.

Adjusting the basic position of the foot brake lever

11.10
Warning
Danger of accidents Brake system failure.
–
If there is no free travel on the foot brake lever, pressure builds up on the rear brake circuit. The rear brake can fail due to
overheating. Adjust free travel on foot brake lever according to specifications.
–
Check that leaf spring
caliper support are seated correctly.
100397-01
–
Fit the brake linings, insert the bolt, and mount the locking split pins.
–
Operate the hand brake lever several times until the brake linings are lying correctly
against on the brake disc and there is a pressure point.
100398-10
–
Correct the brake fluid quantity to level
Guideline
Dimension
top edge of container)
Brake fluid DOT 4 / DOT 5.1 (
–
Position the cover with the membrane. Mount and tighten the screws.
Info
100399-10
Clean up overflowed or spilt brake fluid immediately with water.
–
Disconnect spring
–
Move the foot brake lever back and forth between the end stop and the contact to
the foot brake cylinder piston and check free travel
Guideline
Free travel at foot brake lever
» If the free travel does not meet specifications:
–
Adjust the basic position of the foot brake lever.
–
Reconnect spring
B00028-10
x
in the brake caliper and sliding plate


(brake fluid level below

p. 126)
.

.

in the brake

.
5 mm (0.2 in)
.

3... 5 mm (0.12... 0.2 in)
( p. 73)
x
73