SERVICE WORK ON THE CHASSIS
Checking the fluid level of the hydraulic clutch
10.48
Info
The fluid level rises with increasing wear of the clutch lining discs.
Changing the hydraulic clutch fluid
10.49
Warning
Environmental hazard Hazardous substances cause environmental damage.
–
Oil, grease, filters, fuel, cleaners, brake fluid, etc., should be disposed of as stipulated in applicable regulations.
(All 250/300 models)
–
Adjust the basic setting of the clutch lever to your hand size by turning adjust-
ing screw
Info
Turn the adjusting screw counterclockwise to decrease the distance
between the clutch lever and the handlebar.
Turn the adjusting screw clockwise to increase the distance between the
clutch lever and the handlebar.
The range of adjustment is limited.
B00009-11
Turn the adjusting screw by hand only, and do not apply any force.
Do not make any adjustments while riding!
(All 125/200 models)
–
Move the clutch fluid reservoir mounted on the handlebar to a horizontal posi-
tion.
–
Remove screws
–
Remove cover
–
Check the fluid level.
Fluid level under top edge of con-
tainer
400245-10
»
If the level of the fluid does not meet specifications:
–
–
Position the cover with the membrane. Mount and tighten the screws.
(All 250/300 models)
–
Move the clutch fluid reservoir mounted on the handlebar to a horizontal posi-
tion.
–
Remove screws
–
Remove cover
–
Check the fluid level.
Fluid level under top edge of con-
tainer
B00040-10
»
If the level of the fluid does not meet specifications:
–
–
Position the cover with the membrane. Mount and tighten the screws.
x
.
.
with membrane
.
Correct the fluid level of the hydraulic clutch.
Hydraulic fluid (15) (
p. 127)
.
with membrane
.
Correct the fluid level of the hydraulic clutch.
Brake fluid DOT 4 / DOT 5.1 (
4 mm (0.16 in)
4 mm (0.16 in)
p. 126)
67