Removing The Fork Protector - KTM 125 ECX EU Owner's Manual

SERVICE WORK ON THE CHASSIS

Removing the fork protector

10.9
(XC-W)
–
Position the fork legs.
Info
The upper milled groove in the fork leg must be flush with the top edge
of the upper triple clamp.
Position bleeder screws
303391-10
(EXC EU/AUS, XC‑W)
–
Tighten screws
Guideline
Screw, top triple clamp
–
Tighten screws
Guideline
Screw, bottom triple clamp
B00799-11
(EXC SIX DAYS)
–
Tighten screws
Guideline
Screw, top triple clamp
–
Tighten screws
Guideline
Screw, bottom triple clamp
B00804-11
–
Position the brake caliper and mount and tighten screws
Guideline
Screw, front brake caliper
–
Mount cable binder
–
Position the brake line and wiring harness. Put the clamp on and mount and
tighten screws
–
Install the front wheel.
B00798-11
(All EXC models)
–
Refit the headlight mask with the headlight. (
(XC-W)
–
Install the start number plate. (
x
–
Remove the fork legs.
–
Remove screws
–
Remove the screws on the right fork leg. Lift off the fork protector.
B00801-10
toward the front.

.

.

.

.

M8
.

.

x ( p. 78)
p. 53)
x ( p. 46)
on the left fork leg. Lift off the fork protector.

M8 20 Nm
(14.8 lbf ft)
M8 15 Nm
(11.1 lbf ft)
M8 17 Nm
(12.5 lbf ft)
M8 12 Nm
(8.9 lbf ft)
.

25 Nm Loctite ® 243™
(18.4 lbf ft)
p. 86)
47