Advertisement
Available languages
Available languages
Standby function (ex factory ON)
Select «Extended basic settings»!
When the standby function is switched on, the controls
switch off when no drying programme is running in
energy saving mode. The display will show «ZZZ».
Optical interface (ex factory OFF)
Select «Extended basic settings»!
If the optical interface (SCS) is switched on, customer
services can communicate with the machine by PC.
Default language (ex factory DEUTSCH)
Select «Extended basic settings»!
If another language is temporarily selected via the
select-language button
4 minutes after programme end, in standby mode or
after a long standstill, the setting reverts back to the
default language.
Start time preselection (ex factory 24 HOURS)
Select «Extended basic settings»!
The maximum adjustable range of the start time delay
can be reset from 24 hours to 100 hours.
Mains power
400V 2N ~ 3,4kW / 10A
or the buttons
und
,
64
Cleaning and Care
Cleaning the filters
See chapter «Start programme».
Cleaning the filter support
From time to time it is necessary to remove fluffs that
have accumulated inside the filter support. To do so, use
a vacuum cleaner or a cleaning brush.
X Pull the filters A and B out of the filter support in the
door opening.
X Run the pipe of the vacuum cleaner or the brush around
the well of the filter support.
X Remove any residual fluff.
X Replace the two filters properly.
X Close the door.
Cleaning the moisture sensor
After longer operation, small deposits (lime, fabric
refiner) can form on the front inner side of the drum on
both sides of the longish moisture sensors.
With moisture controlled programmes, this can result
in the desired level of dryness not being reached.
Wipe deposits away with a cloth soaked in vinegar.
Advertisement
Chapters
