Brocade Communications Systems NetIron CES Series Hardware Manual page 50

3
Redundant power supply installation
CAUTION
For the NEBS compliant installation of a Brocade NetIron CES and Brocade NetIron CER 2000
series devices with AC and DC system use a ground wire of at least 6 American Wire Gauge
(AWG). The ground wire should have an agency-approved crimped connector (provided with the
chassis) attached to one end, with the other end grounded to either a common bonding network
or an isolated bonding network. The connector must be crimped with the proper tool, allowing it
to be connected to both ground screws on the enclosure. Before crimping the ground wire into
the provided ground lug, insure the bare copper wire has been cleaned and antioxidant is applied
to the bare wire.
CAUTION
To insure adequate bonding when attaching the provided Panduit LCD6-10AF two-hole ground
lug, a minimum of 20 PSI of torque is required to be applied to the mounting hardware used to
attach the ground lug. Use a star washer to ensure an NEBS compliant connection.
38 Brocade NetIron CES and Brocade NetIron CER Hardware Guide
53-0000080-03