Brocade Communications Systems NetIron CES Series Hardware Manual page 72

5
Power supply replacement
Removing the AC power supply
Required tools
You will need the following tool to perform this procedure:
The following procedures are required when removing an AC power supplies from a device.
1. Unplug the power supply from the power source.
2. Disconnect the power cord from the power supply.
3. Unscrew the two power supply locking screws located at the top left and bottom right hand
FIGURE 38
4. Pull the power supply outward once the screws have been unscrewed. This will disconnect the
60
•
#2 Phillips-head screwdriver
corner of the power supply.
Power supply screw location
1 Power supply locking screws
power supply from the backplane.
Brocade NetIron CES and Brocade NetIron CER Hardware Guide
53-0000080-03