Installation Steps - Brocade Communications Systems NetIron CES Series Hardware Manual

3
Device installation
FIGURE 36
I

Installation steps

1. Mount the device in the rack as illustrated in
2. Using a 2-hole grounding lug and a minimum #6 AWG grounding wire, ground the chassis to
3. Proceed to
You will need the following tools for installation:
•
•
42
Installing the Brocade device in a rack
either a common bonding network or an isolated bonding network.
"System power"
#2 Phillips-head screwdriver
Four #10-24 screws (or as specified by rack type) to mount the device to the rack
Figure 36.
on page 43.
Brocade NetIron CES and Brocade NetIron CER Hardware Guide
53-0000080-03