Brocade Communications Systems NetIron CES Series Hardware Manual page 29

TABLE 5
Part number
E1MG-100BXU
E1MG-100BXD
E1MG-100FX-IR
E1MG-100FX-LR
10 Gigabit Ethernet ports
A 10 Gigabit Ethernet module contains two or four physical ports, through which you can connect
your device to other network devices at a speed of 10 Gigabits.
Into a physical port, you must insert a fiber-optic transceiver provided by device. The
XFP/SFP+-compliant fiber-optic modules provide an optical transceiver or physical
medium-dependent (PMD) interface for single or multi-mode fiber that can be used with the LAN
physical layer (PHY).
The following 10 Gigabit optics are available from device.
TABLE 6
Part number
Devices with up to two 10GbE ports (XFP)
10G-XFP-SR
10G-XFP-LR
10G-XFP-ER
10G-XFP-ZR
10G-XFP-ZRD
10G-XFP-CX4
Devices with up to four 10GbE ports (SFP+)
10G-SFPlus-SR
10G-SFPlus-LR
10G-SFPlus-ZR
10G-SFPlus-ZRD
Port regions
Ports on the devices are grouped into regions. For a few features, such as port monitoring and
unknown unicast configurations, you will need to know the region to which a port belongs. However,
for most features, a port's region does not affect configuration or operation of the feature. If a
port's region does affect configuration or operation of a feature, it is noted and described in the
appropriate feature section of this guide.
Brocade NetIron CES 2024, Brocade NetIron CER 2024 devices with 24 ports:
•
•
Brocade NetIron CES and Brocade NetIron CER Hardware Guide
53-0000080-03
SFP-compliant transceivers for the 100/1000 Ethernet interface module (Continued)
Description
100Base-BXU SFP optic single-mode fiber, 1310nm, LC connector.
This optic can only be connected to an E1MG-100BXD.
100Base-BXD SFP optic single-mode fiber, 1490nm, LC connector.
This optic can only be connected to an E1MG-100BXU.
100BaseFX-IR optic for SMF with LC connector. For distances up to 15nm.
100BaseFX-LR SFP optic for SMF with LC connector. For distances up to 40km.
MSA-compliant Optics for the 10 GbE Ethernet interface module
Description
850nm serial pluggable XFP optic, target range 300m over multi-mode fiber
1310nm serial pluggable XFP optic for up to 10km over single-mode fiber
1550nm serial pluggable XFP optic for up to 40km over single-mode fiber
1550nm serial pluggable XFP optic for up to 80km over single-mode fiber
10GBase-ZR DWDM, XFP optic, 80km, 1530.33 to 1561.42
10-Base-CX4, XFP transceiver, 15km, CX connector
Ports 1/1 – 1/24
Port 2/1 (optional 10-GbE uplink port)
Hardware features
1
17