Hardware Maintenance; Hardware Maintenance Schedule; Power Supply Replacement - Brocade Communications Systems NetIron CES Series Hardware Manual

Hardware Maintenance

Hardware maintenance schedule

DANGER
The procedures in this manual are for qualified service personnel.
The Brocade device requires minimal maintenance for its hardware components. Brocade
recommends cleaning the fiber-optic connectors on a fiber-optic port and the connected fiber cable
each time you disconnect the cable.
Otherwise, you can install or replace the following hardware components as needed:
•
•
•
•

Power supply replacement

You can replace a power supply while the Brocade device is powered on and running. The power
supplies are located in slots at the rear of the device.
This section provides information about the following topics:
•
•
•
DANGER
Power supplies are hot swappable. However, Brocade recommends that you disconnect the
power supply from AC power before installing or removing the supply. The device can be running
while a power supply is being installed or removed, but the power supply itself should not be
connected to a power source. Otherwise, you could be injured or the power supply or other parts
of the device could be damaged.
Brocade NetIron CES and Brocade NetIron CER Hardware Guide
53-0000080-03
Copper and fiber optic modules
Power supplies
Fan tray
2 x10-Gigabit Ethernet module (only on the Brocade NetIron CES 2024C, Brocade NetIron CES
2024F, Brocade NetIron CER 2024C, Brocade NetIron CER 2024F models.
Installation precautions and warnings
Determining which power supply has failed, if necessary.
Replacing a power supply.
Chapter
5
57